Why are trials levers so long when the last few centimetres never get used — crushing your fingers up close, causing arm pump farther out, and sticking out ready to bend on impact?

We built a better one. The patented one-finger profile eliminates interference, expands your adjustment range and contours to your finger, so you can pull all the way to the bar without smashing the others — with a ball end for safety and FIM compliance. A more progressive bite point gives smoother engagement and finer control.

Levers fit all Braktec / AJP / Beta / Grimeca master cylinders. The toolless master-cylinder adjusters fit Braktec.

Levers include 1× copper bushing and 1× oversized plastic bushing — copper on top, plastic on bottom. For Beta / Grimeca master cylinders no bushing is needed; install with the stock bolt.

Don't over-tighten the master-cylinder clamp bolts (4–6 Nm). A wrap of plumber's tape under the clamp lets it pivot in a crash, protecting both lever and cylinder.

• Standard lever — 75 mm from centre of mounting hole to middle of finger position
• OEM Braktec lever — 68–90 mm